Peaktool aluminum mold for dovetail 38 cm

This Peaktool jig is suitable for milling dovetail joints using a router table with a mounted router. The jig is screwed onto the end of a custom-made panel, allowing workpieces to be attached on both sides.

The jig is then moved over the router table, allowing the included router bits with their bearings to pass through the openings of the jig to mill the shape. This is a very suitable jig if you want to create the same type of joint repeatedly.

You can also connect two jigs for a longer jig. There are two screw holes at the end for attaching two jigs together.

Includes:

• Bearing-guided dovetail router bit (11 mm x 19 mm), shaft 6.35 mm
• Bearing-guided straight router bit (Ø15.8 mm x 19 mm), shaft 6.35 mm